Cool Components Variable Speed Temp Controller

A professional grade temperature controller for low voltage fans used primarily in audio video and other technology based cooling applications. The unit is easy to install and configure, basically ‘set it and forget it’ for many years to come. The variable speed control is ideal for applications where noise and effectiveness are equal concerns as the fans run at the speed necessary to provide adequate cooling.

General Specifications

• Dimensions (Unit):   3" x 1 5/16" x 3/4” (7.6 cm x 3.4 cm x 2 cm)
• Construction:           ABS Black Housing w/Mounting Slots

Power Specifications

• Power Connection:     2-Pin or 2.1mm Coax Connector (Ensure Proper Polarity)
• Fan Connection:         2-Pin FastWire Connector System- Additional cables may are necessary for multiple fans and/or longer cable runs (Available Y, Tri & Extension Cables)
• Sensor Type:             Remote Sensor – Measures ohms and can be extended further with only slight change in reading and function
• Input Voltage:           12-13.5V DC
• Current - Amperage:  Output Rated at 2 Amps (Depending on application can connect more than 2A of fans since with proper design the fans will not run at 100%)

Function

• Fan Modes:                Mode 1 = 70°F, Mode 2 = 80°F, 3=90°F, 4=100°F, 5=110°F
• Alarm Modes:            Mode 1 = Off, Mode 2 = 115°F, Mode 3 = 125°F
• Fan Speed Variance:   Fans On at 50% Speed, 100% at +10°F

Home Theater Recommended Practice: Equipment cooling and ventilation

Recommendations:

Ambient Room Conditions

• Temperature: 20◦ - 23◦C

Equipment Conditions

• Operating Temperature:≤ 29◦C

• Fresh Air Inlet to Rack/Cabinet: 24◦C

Note A; 99.6% of all power (electricity) going into a rack is converted to heat

Note B; for approximately every 5◦C above 29◦C, reliability of equipment drops 50%